Ad-weighing SV-100 Manuel d'utilisateur télécharger pdf (Page 22)

5-3 Changing Units

The units of viscosity available are: mPa⋅s (millipascal second),

Pa⋅s (Pascal second),

cP (Centipoise),

P (Poise).

The correlation of the units are as follows: 1 mPa⋅s = 0.001 Pa⋅s = 1 cP =0.01 P

The units of temperature available are: °C (Celsius) and °F (Fahrenheit).

The unit selected upon power-on depends on the function setting. The unit selected at the factory

before shipment is as shown below.

Model Viscosity Temperature

SV-10 mPa･s

SV-100 Pa･s

°C

Use the MODE key to change units. Each time the MODE key is pressed, units are switched as below:

Note that the unit of temperature is fixed in the function setting.

SV-10

 In the function setting, mPa⋅s or Pa⋅s is selected:

 In the function setting, cP or P is selected:

SV-100

Note

While the measurement is being performed using the graphing program RsVisco, unit

changes using the MODE key is not available.

With the function setting "fnc 1", pressing the MODE key during measurement will display

the measurement elapsed time.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 65 66

Pas de commentaire

Ad-weighing SV-100 Manuel d'utilisateur Page 22